OPERATING INSTRUCTIONS   Model # 1600  Airbrushing Compressor

READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE  INSTALLING OR USING YOUR AIR COMPRESSOR UNIT - IT CONTAINS VALUABLE INFORMATION THAT WILL HELP YOU IN THE SAFETY INSTRUCTION - RECEIVING - INSTALLATION - USE - AND MAINTENANCE OF THE UNIT

Oil-Less - Oil free operation SUPER QUIET OPERATION! 30 PSI Easy Drain Moisture Filter 1/8" BSP and 1/4" BSP Adapter 110 Volts - .75 Amps On/Off switch Attached Airbrush Holder 3 Month Warranty Manufacture: Airbrush City Each Airbrush City air compressor outfit is carefully factory tested and inspected before shipment.  Every attempt is made to ensure a safe and complete shipment of our products.  It is the responsibility of the receiver of the goods to ensure the product has been shipped in full, and the arrival is in suitable condition to avoid expenses being incurred to correct such problems.  In the event a product has arrived with damage, contact Airbrush City immediately.

Attach Filter	Use liberal amount Teflon tape on threads	Start union, hand tight, into filter.	Attach Filter to compressor turning Clockwise until very snug and vertical. DO NOT OVER-TIGHTEN	Compressor is now ready to use

Your 1600 Airbrush Compressor is oil-less and maintenance free. The only maintenance is to drain any condensation that may build up after use in the moisture filter.

MECHANICAL Locate the compressor in a clean, dry and well ventilated area. Place the air compressor on a firm and level surface.  The air compressor is designed with heat dissipation fins that allow for proper cooling.  Keep the fins and other parts that collect dust or dirt clean.  A clean compressor runs cooler and provides longer service.

ELECTRICAL It is your responsibility to ensure that the air compressor is electrically connected in a safe and correct manner.  Any electrical work should be carried out by a competent electrician and installed in a way which meets all applicable codes and regulations.

ON/OFF FEATURE The compressor is equipped with an on/off switch. When not spraying, always turn the compressor to off position.

MOISTURE FILTER After each use, you may want to drain the moisture filter. Turn the drain valve on bottom of filter 1/4 of turn and run compressor for a few seconds. This will release any condensation trapped in moisture filter.

1/8 BSP to 1/4BSP ADAPTER Your compressor comes with a 1/8 to 1/4 BSP thread adapter. Many airbrush airlines manufactures use the standard in the industry 1/8 BSP and 1/4 BSP threads on their airlines. Some manufactures have their own special threads, so you can only use their equipment.  We have supplied this adapter to allow you to connect most airbrush airlines to this compressor.

IMPORTANT SAFETY INSTRUCTION

IMPROPER OPERATION OR MAINTENANCE OF THIS PRODUCT COULD RESULT IN SERIOUS INJURY AND PROPERTY DAMAGE.

RISK OF FIRE
DO NOT SPRAY  COMBUSTIBLE  OR FLAMMABLE  LIQUID IN A CONFINED AREA - SPRAY AREA MUST BE  WELL VENTILATED.

DO NOT SMOKE WHILE  SPRAYING OR SPRAY WHERE  SPARK OR FLAME  IS PRESENT.

ARC PARTS KEEP COMPRESSOR AT LEAST 12 - 18 INCHES AWAY FROM SPRAYING AREA AND ALL EXPLOSIVE VAPORS.

RISK OF ELECTRICAL SHOCK

DISCONNECT COMPRESSOR FROM ELECTRICAL SUPPLY CIRCUIT BEFORE  SERVICING.

DO NOT EXPOSE COMPRESSOR TO RAIN OR OPERATE IN A WET AREA

NEVER USE  THE  AIR COMPRESSOR  WITHOUT CONNECTION TO A PROPERLY GROUNDED OUTLET WITH THE SPECIFIED VOLTAGE AND FUSE  PROTECTION.

THE COMPRESSOR MUST BE  LOCATED A MINIMUM OF 12-18 INCHES FROM ANY  SOURCE OF POTENTIALLY EXPLOSIVE VAPORS.

IMPROPER GROUNDING CAN RESULT IN ELECTRICAL SHOCK