2007GF - Needle & Head Exchange

	1. Unscrew & remove handle from the airbrush body.
	2. Turning counter-clockwise, carefully loosen the needle set screw.
	3. Carefully pull back on the end of the needle, removing the needle from the airbrush body.
	4. Turning counter-clockwise, remove the cap / head from the airbrush body.
	5. Using the wrench provided in your set, carefully loosen (turning counter-clockwise) and remove the "Nozzle" from the airbrush.
	6. If cleaning is necessary, it is recommended to remove the material cup. Carefully turn counter-clockwise & remove.
	7. Inspect all parts and clean as necessary. 7b. When changing the needle & head/cap assemblies, be sure to use the matching parts when reassembling your airbrush. (i.e. head/cap size to needle size).
	8. When reassembling your airbrush, first replace the "Nozzle" and lightly snug tight with the provided wrench.
	9. VERY carefully insert the needle into the airbrush body. When inserting, turn the needle slowly while carefully pushing forward until needle is seated into the nozzle.
	10. Once the needle is set, lightly snug the "Needle Set/Stop Screw" to lock the needle in place.
	11. Replace the "Needle Cap", carefully turning clockwise until "Hand Snug".

Now that your airbrush has been re-assembled, you should first test the airbrush by spraying air only, then spray cleaner through. You may use cleaner to assist you to properly adjust your spray pattern and desired material "flow". This is achieved by turning the Needle Adjustment Sleeve back and forth. You may have to remove & replace the needle cover (handle) several times until it is adjusted & set to your preferred operation.